Waveshare Core429I, STM32F4 Core Board

Product Description

Overview 1. Core429I is an STM32 MCU core board designed for STM32F429IGT6, supports further expansion. It is ideal for starting application development with STM32F family. 2. Minimal ready-to-run system, integrates clock circuit, USB power management, USB connector, etc. 3. Onboard 64M Bit SDRAM 4. All the I/O ports are accessible on the pin headers 5. JTAG/SWD programming/debugging interface 6. 2.0mm header pitch, allowed to be plugged-in your application board What is on the Core429I STM32F429IGT6 development board on board resource 1. STM32F429IGT6: The high performance STM32 MCU which features: - Core: Cortex-M4 32-bit RISC - Feature: single-cycle DSP instructions - Operating Frequency: 180MHz, 225 DMIPS/1.25 DMIPS/MHz - Operating Voltage: 1.8V-3.6V - Package: LQFP176 - Memories: 1024kB Flash, 256+4kB SRAM - MCU communication Interfaces: -- 6 x SPI, 4 x USART, 4 x UART, 2 x I2S, 1 x SAI, 3 x I2C -- 1 x FMC, 1 x SDIO, 2 x CAN -- 1 x LCD-TFT -- 1 x USB 2.0 HS/FS controller (with dedicated DMA) -- 1 x USB HS ULPI (external PHY required) -- 1 x 10/100 Ethernet MAC -- 1 x 8 to 14-bit camera interface - AD & DA converters: 3 x AD (12-bit, 1μs, shares 24 channels); 2 x DA (12-bit) - Debugging/Programming: supports JTAG/SWD interfaces, supports IAP 2. IS42S16400J: SDRAM 1 Meg Bits x 16 Bits x 4 Banks (64-MBIT) 3. AMS1117-3.3: 3.3V voltage regulator 4. MIC2075: onboard USB power management device 5. Power supply switch, powered from 5Vin or USB connection 6. Boot mode selection, for configuring BOOT0 pin 7. Power indicator 8. VBUS LED 9. Reset button 10. 8M crystal 11. 32.768K crystal, for internal RTC with calibration 12. JTAG/SWD interface: for debugging/programming 13. USB connector, supports Device and/or Host 14. MCU pins expander, VCC, GND and all the I/O pins are accessible on expansion connectors for further expansion 15. 5V in pinheader, 5V power supply is required when using USB HOST/OTG 16. USB OTG/HOST jumper - Short the jumper when using USB OTG/HOST - Open the jumper to disconnect from related I/O port 17. VBAT selection jumper - Short the jumper to use system power supply - Open the jumper to connect the VBAT to external power, such as battery 18. VREF selection jumper - Short the jumper to connect VREF+ to VCC - Open the jumper to connect VREF+ to other custom pin via jumper wire

Specifications

SKU

ZY13988464

Category

Consumer Electronics › Electronics Module › MCU Tools

Weight

0.12 kg

Delivery

Standard delivery